If you do not have any experience to install the split screen, you will take a few risk of breaking the camera when you install it. So you’d better install it under the guide of the experienced man.

Note:

We only offer an installation instruction as following. The split screen may be not the same, but the installation method is the similar.

In the installation instruction, some tools we do not offer, you can use the similar tools to replace.

If you do not have any experience to install the split screen, you will take a few risk of breaking the camera when you install it. So you’d better install it under the guide of the experienced man.

We are not responsible for any broken or damage caused when you install this item, except the quality problem of the item itself.

Pls prepare the split screen, tweezer, fingerstall and cleaning your hands, then Start.

Step1	Step2
This is the CANON EOS 5D camera	You can see the focusing screen in the top of inside

Step3	Step4
Tweezers arrowhead is Attachment hook	Use the tweezers clip tightly a switch and push outwardly, Can open screen lock

Step5	Step6
The focusing screen lock have already opened	Please store original focusing screen careful

Step7	Step8
Please take out foam(we do not offer this foam. It’s not necessary, if you like you can use the similar item to replace)	Take out a bar of foam

Step9	Step10
Take out a bar of foam	Stick to the focus point screen the top side.(Please watch for the direction of )

Step11	Step12
This purpose wants to depend on tight base surface (The base surface is in the under screen )	Please clip the focusing screen edge and put the inside of the camera.

Step13
Operate carefully until it locks in place.If the center position has few deviation,you can flutter camera lightly then again fixed,Until the screen position is correct.

~~Then test~~
This image is the accurate center	This is the appearance which didn't focus .

Step16
This is the focus appearance.